Boeing Specification D6 17487

By | April 30, 2022

Boeing Specification D6 17487. Techspray’s g3 solvents were developed with patented technology to replace ozone depleting solvents containing General) page 1 of 3 acrylic crazing test:

P&S Detail Products’ Bead Maker is Now Boeing D617487 Approved
P&S Detail Products’ Bead Maker is Now Boeing D617487 Approved from detailingsuccess.com

Techspray’s g3 solvents were developed with patented technology to replace ozone depleting solvents containing Aluminum sandwich corrosion test, acrylic crazing test, paint softening test, and hydrogen embrittlement test. General) page 1 of 3 acrylic crazing test:

Tests Were Performed By Outside Laboratory Smi, Inc.

Make final determination regarding compliance to boeing requirements. Aluminum sandwich corrosion test, acrylic crazing test, paint softening test, and hydrogen embrittlement test. Hydrogen embrittlement testing shall be in accordance with astm f 519 using cadmium plated type la.2, type lc, or type 2a specimens.

Protektiv Has Been Tested Against The Stringent High Standards Set Out For Boeing Compatible Products.

General) page 1 of 3 acrylic crazing test: General cleaning mater ial i inc. Sandwich corrosion test this test evaluates if the product being tested causes additional corrosion from a control group, in various settings (humidity/temperature.

Specimen Preparation, Testing, And Interpretation Shall Be In Accordance With Astm Fl 110 Using The Following Materials And With The Following Exceptions:

Cleano® suffered no failures on any of the four specimens in this test. It is the best choice for routine, experienced operators. This document is an expression of the expectation by the boeing.

Protektiv Is Manufactured Using Nano Ceramic And Silica Dioxide, The Same Material That’s Used In The Glass Manufacture Process.

Specification applies to products used as exterior and general aircraft cleaners. These test are performed to assure, with a high degree of confidence, that the product is safe for use on aircraft. All requirements of astm f519 for specimens, preparation, testing, and reporting shall apply.

Requirements Are Described In Three Appendixes And Two Addenda, The Applicability Of Which Shall Be Defined By Contract.

Four cadmium plated specimens are notched and then emerged in the product for 150 hours, under a constant 45% load. Sandwich corrosion test paint softening test. Hydrogen embrittlement testing shall be in accordance with astm f 519 using cadmium plated type la.2, type lc, or type 2a specimens.

Leave a Reply

Your email address will not be published. Required fields are marked *